Parkside PMML 5 A2 Instructions D'utilisation Et Consignes De Sécurité page 35

several centimeters further to the right or
left of the previous surface and recali-
brate. Start the search process.
- Repeat several times to ensure the
detection accuracy.
- Incorrect measurements can occur de-
pending on the nature of the examined
wall. Check therefore before every
measurement the position of a known
wooden or metal beam, or a known
power line. If these are not detected by
the product, the substrate is not suitable
for a search with this product.
- Avoid touching the display during meas-
urements as it may affect the accuracy
of the device.
- Please note that power lines can also be
located as metal or as beams. Always
use the additional voltage search, so
that you can exclude any incorrect inter-
pretations.
- Please note that metal beams are also
detected in the Beam search "STUD"
function. If you find a beam and you want
to be sure that it is not a metal beam
GB/IE/NI 35