Continuous Distance Measurement Mode - Parkside PMML 5 A2 Instructions D'utilisation Et Consignes De Sécurité

mode will be indicated on the LC dis-
play
2
Note:
If not pressed any button for 30 sec-
onds, the laser beam will turn off au-
tomatically. In this case, press the MEAS
button
If not pressed any button for 60 sec-
onds, the display
off automatically. In this case, press
the POWER button
display. Then, press the MEAS button
to turn on the laser beam.
6
3. Briefly press the MEAS button
again. The measured distance will be
appeared on the display
Note:
- New distance measurement can be
done by repeating step 2 to step 3.
- Measured values can be cleared by
pressing MODE button
Continuous distance
measurement mode
For continuous distance measurement,
follow the step 1 & step 2 of single distance
26 GB/IE/NI
by a flashing laser symbol
to turn on the laser beam.
6
2
will be turned
to turn on the
12
.
2
.
10
.
26
6