Important Information - CertainTeed NO-COAT PRO Manuel D'instructions

INDUSTRY CANADA NOTICE
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device.
IMPORTANT INFORMATION BEFORE USING NO-COAT PRO
Recommended Compounds
CertainTeed recommends ready-mix All-Purpose joint compound thinned with water ONLY for
use in the NO-COAT PRO machine when running corners.
Modification of NO-COAT PRO
DO NOT modify this machine with non-CertainTeed products, as modification could affect
performance, safety or durability. In addition, damage or performance problems resulting from
modification may not be covered under warranty. NO-COAT PRO is engineered to be used with
the NO-COAT PRO Corner roll product ONLY.
Using Roll Product in the Machine
NO-COAT PRO is engineered to be used with the NO-COAT PRO Corner roll product ONLY.
Moving NO-COAT PRO
If the NO-COAT PRO hopper is full of joint compound, CertainTeed recommends removing the
hopper assembly before maneuvering the NO-COAT PRO machine.
Storing NO-COAT PRO
DO NOT store the NO-COAT PRO machine in temperatures below 32˚F (0°C).
Do NOT operate machine if it is wet.
Remote Control
The NO-COAT PRO Remote Control is NOT waterproof. Do not spray or submerge in water. Clean
with moist towel only.
IMPORTANT: Save shipping boxes in the event that factory servicing of the NO-COAT PRO is
required. Failure to ship NO-COAT PRO in the original packaging or packaging approved by
CertainTeed could void warranty.
8 NO-COAT PRO INSTRUCTION MANUAL
®