Setting For Inside Or Outside Corner Trim - CertainTeed NO-COAT PRO Manuel D'instructions

To load NO-COAT PRO Corner into the NO-COAT PRO machine:
1. Push in perforated section above finger hole.
2. Tear out perforated large end panel and remove.
3. Using finger holes, remove perforated panels on both sides of the box.
4. Lift box with perforated end panel facing machine, and mount over spindle.
5. Box should fit snugly against spindle arm, resting on the spindle and corner pin (as
shown in #7).
6. On opposite box side, make sure box sits on spindle and is secured in place by
spindle cap.
8. Pull end of NO-COAT PRO Corner out of box and slide under guide pin.
9. Feed NO-COAT PRO Corner through open slot into feed rollers using the feed knob.
Make sure center groove in product lines up with centering roller. Turn feed knob until
product stops against inside cutter blade.
10. To remove or adjust position of NO-COAT PRO Corner, push down on feed release
lever.
Setting for outside or inside corner
For an outside corner:
1. Rotate the folder handle away from you until the folder handle rests against the stop
pin in the OUT position.
2. Locate the hopper with the tapered feet in the far set of locating holes.
Feed Rollers
Guide Pin
Centering
Roller
Feed Knob
Guide
Feed
Release Lever
NO-COAT PRO INSTRUCTION MANUAL
®
T
urn Feed
Knob
counter-
clockwise
only!
15