Running Corners; Exit "Run Mode; End Of Roll - CertainTeed NO-COAT PRO Manuel D'instructions

RUNNING CORNERS

Enter "run mode":
1. Make certain the product is loaded properly and the product box is touching the end
of the NO-COAT PRO.
2. Make certain the folder and hopper are both set for the desired corner (inside or
outside).
3. Press RUN or the remote button to enter "run mode" and dispense the first corner on
the list.
4. To pause the corner output, press STOP or the remote button during output -
press RUN or the remote button to resume.
5. Press RUN or the remote button to dispense the next corner on the list.
Pulling corners out of the NO-COAT PRO
1. Support the corner as it comes out of the NO-COAT PRO. Wait to pull out the product
until you hear the NO-COAT PRO cut the corner - if you pull the corner before the cutter
fires, it may cause length errors.
2. After the NO-COAT PRO cuts the
corner, be certain to pull the corner
from the NO-COAT PRO smoothly
and at a consistent speed to ensure
optimal joint compound coverage on
the corner. Pulling the corner out too
rapidly may result in gaps in joint
compound coverage. Also, be careful
to pull the corner straight out and
level, to avoid deforming the corner.
3. Do not run another corner until
you have removed the previous
corner from the NO-COAT PRO.

Exit "run mode"

1. Press STOP to exit "run mode" in order to edit the corner data, edit the list, recall a
stored list, etc.

End of roll

In the event that the end of a roll is reached while dispensing a corner the NO-COAT
PRO will stop dispensing and not cut.
1. Remove the current corner from the NO-COAT PRO. DO NOT PRESS CUT BEFORE
REMOVING THE CORNER - pressing cut before removing the corner may cause a small
piece of product to remain in the cutter which may jam the NO-COAT PRO.
2. Press CUT to reset the NO-COAT PRO.
3. Load a new roll of product, making certain that the product stops against the cutter
blade (to ensure proper corner length).
4. Press RUN to repeat the corner or press ENTER to skip to the next corner.
NO-COAT PRO INSTRUCTION MANUAL 19
®