Storing The Hopper; Troubleshooting - CertainTeed NO-COAT PRO Manuel D'instructions

2. Wipe down the NO-COAT PRO with a
damp sponge, removing joint compound
from all surfaces.
3. If necessary, remove and rinse off
the mud pan. Don't forget to replace the
mud pan when finished.
4. If necessary, remove and rinse off
the folder by rotating the folder until
the screws line up with the notch in the
frame. Don't forget to replace the folder
when finished.

Storing the hopper

To reduce the amount of cleaning each day the hopper can be stored overnight, with or
without joint compound.
1. Place lid on top of hopper.
2. Place hopper into a clean 5-gallon bucket filled with 5" of water.

TROUBLESHOOTING

Issue: Display is blank.
Check the following:
1. The NO-COAT PRO is unplugged.
Solution: plug the NO-COAT PRO in to grounded outlet.
2. The NO-COAT PRO is turned off.
Solution: turn on the NO-COAT PRO machine.
3. The NO-COAT PRO fuse is blown.
Solution: replace the fuse with a 5 x 20 mm, 6.3A, 250V, slow-blow fuse.
4. The cooling fan is running but the display is blank.
Solution: The NO-COAT PRO has power but the display may be defective – call
Customer Service at 1-800-233-8990.
Issue: Unable to edit data.
Check the following:
1. NO-COAT PRO is in "run mode".
Solution: press stop to exit "run mode".
Issue: Display reads "FEED ERROR"
Check the following:
1. The product is not loaded correctly.
Solution: Make certain the product is loaded correctly and the center groove in the
product lines up with the centering roller.
2. The product is jammed in the NO-COAT PRO.
Solution: inspect the cutter, folder, and hopper for product jam.
Solution: make certain the folder and hopper are in the proper setting (both set for
inside or outside corner).
Frame
Notch
Guide
Screws
NO-COAT PRO INSTRUCTION MANUAL
®
Folder
21