Bang & Olufsen BeoVision 1 Update III Instructions De Service page 19

Finish the on-site service
#7 Check after replacement of main chassis or modules
Disconnect the ESD mat from the main chassis
Mount back cover
Picture
Sound
Other
Check that the surfaces of the TV are clean, if not they should be cleaned
- If a non-customer VTR has been used V.TAPE must be set to NONE. Select OPTIONS
in SETUP. Select CONNECTIONS and set V.TAPE to NONE. Press GO to exit SETUP.
- See #7 Check after replacement of main chassis or modules, for fi nishing the
on-site service.
- Remove the alligator clip from the aerial input on the main chassis.
- The back cover can now be mounted. Fasten the screws (Please see 10.1
Disassembly/Assembly).
- Place the TV in its original stand and place and connect all the cables.
- Check that picture on all internal and external sources works correctly.
- Check if teletext works correctly.
- Check geometry of both format 4:3 and format 16:9. Adjust if neccesary.
- Check that sound on all sources works correctly. Remember satellite and
videotaperecorder, if these are present.
- If a videotaperecorder is connected to the TV, check whether the record and
playback functions work correctly.
- If the TV is mounted with a motor stand, this should be calibrated. Enter SETUP,
select SERVICEMODE with 0, 0, GO. Press the button combination within 3
seconds. Select STAND with GO. Press GO to calibrate the television. When done
and CALIBRATION OK is displayed, press GO to exit. Then check if the stand works
correctly.
- See #5 Removal of the contrast screen and cleaning the television for more
information.
Adjustments, English 2.17