Hoover ROBO.COM2 RBC040 Manuel D'instructions page 9

GB
RoboCom2Manual2011__GB.indd 8
USING YOUR ROBO.COM² CLEANER
Power On
1. Press the on / off switch on the side of the Robo.com².
2. The LCD screen will illuminate.
NOTE: If your robot is already switched On, but in standby mode, it can be activated from the remote control**
or pressing one of the touch sensitive keys.
NOTE: The touch sensitive controls on the Robo.com² can be unreliable if your hands are wet.
Setting the Day /Time on the Robo.com²
1. Using the Remote Control** press the time set button. A flashing line will appear below the day.
2. Use the up and down arrow on the Remote Control** until the line appears below the correct day. Press
the OK Confirmation Button.
3. The hour display will flash. Press the up and down arrow on the Remote Control** until the correct hour
is displayed. Press the OK Confirmation Button.
4. The minute display will flash. Press up and down arrow on the Remote Control** until the correct minute
is displayed. Press the OK Confirmation Button.
5. Day and time are now set.
Cleaning Programs
Robo.com² uses AAI™ Infrared Navigation, an advanced navigation system that uses the algorithmic calculation
to define the best path to efficiently clean your room.
Press the AUTO Sensitive touch control on the robot or press the AUTO button on the remote control to activate
the Automatic cleaning mode. Robo.com² will automatically choose the best cleaning mode to clean your
room. It will use 4 different cleaning patterns:
ZIG ZAG
Press the SPOT Sensitive touch control on the robot or press the SPOT button on the remote control to activate
the SPOT cleaning mode. Use this mode to intensively clean a confined area. Robo.com² will move following a
elliptical pattern, where the radius will continuously increase for approximately 3 minutes.
With the Remote Control**, you can also activated all the other cleaning programs:
Manual Navigation:
The Robot can be controlled manually at any time during a cleaning program. The
navigation arrow keys in the remote control will move the Robot in the desired
direction with the suction activated. With the remote control, the Robo.com² can
be controlled up to a distance of 10m, even behind a wall.
Full & GO: When the robot is charging, press the FULL & GO button on the remote control to
activate this cleaning mode. On the display the AUTO indicator will start flashing.
When the battery is fully charged, the Robo.com² will automatically start a cleaning
cycle. Once complete, the Robo.com² will automatically return to the Charger Base
Station.
TURBO*: Press the TURBO* button on the remote control to activate the TURBO* speed. The
TURBO* indicator will light on in the LCD display. Robo.com² will start to work at a
faster speed, covering quicker the area to clean.
Scheduled Cleaning*:
You can decide what time the Robo.com² will start cleaning, daily or weekly. To set
a cleaning schedule follow see 'Setting Up The Cleaning Schedule' .
* Certain Models Only
** May vary according to model
EDGE ELLIPTICAL SQUARE
14/07/2011 13.40.05