Hoover ROBO.COM2 RBC040 Manuel D'instructions page 14

MAINTAINING YOUR ROBO.COM² CLEANER
Cleaning the Sensor Window
The wall detection sensors are located in the front of Robo.com². Clean the sensor window each time the dust
container is emptied. Frequent cleaning is recommended to ensure optimum performance of your Robo.
com².
Use a dry soft cloth or cotton swab to wipe the sensor window.
Cleaning the Floor Polisher Pad*
1. Turn the Robo.com² off.
2. Press the dust container release button and and remove the dust container from the Robo.com².
3. Press the Floor Polisher Pad Holder* release button and unclip from the dust container.
4. Tear the Floor Polisher Pad* from the Floor Polisher Pad Holder* and wash using hand warm water.
Remove excess water and leave to dry before re-using.
5. Re-assemble when fully dry.
Replacing the batteries
Only use approved replacement parts for your Robo.com². Using parts not validated by Hoover are dangerous
and will invalidate your guarantee.
If the Robo.com², Virtual Barrier* and Remote Control** is not to be used for several months please remove the
batteries and store in a dry location.
IMPORTANT: Always make sure your device is switched off before changing your batteries.
Replacing the Robo.com² batteries
The Robo.com² is fitted with a rechargable battery pack.
1. Turn the Robo.com² over and place on a level surface. Remove the screws from the battery cover and
then remove the battery cover.
2. Remove the old battery pack and replace with the new battery pack ensuring the polarity is correct.
Replace the cover.
3. Recharge the Robo.com².
Replacing the Remote Control** batteries
The Remote Control** is fitted with 2 x AAA batteries.
1. Slide the battery cover open.
2. Remove the old batteries and replace with the new batteries ensuring the polarity is correct. Replace
the cover.
Replacing the Virtual Barrier* batteries
The Virtual Barrier* is fitted with 2 x D batteries.
1. Turn the Virtual Barrier* over and rotate the retaining clip. Remove the battery cover.
2. Remove the old batteries and replace with the new batteries ensuring the polarity is correct. Replace
the cover.
* Certain Models Only
** May vary according to model
RoboCom2Manual2011__GB.indd 13
GB
14/07/2011 13.40.17