Binzel Abicor CAT2 Mode D'emploi page 43

CAT2
10 Troubleshooting
Fault
Torch mount cannot
be mounted.
CAT2 does not switch
stop signal
CAT2 does not reset
to zero position
Tab. 13
Troubleshooting
DANGER
Risk of injury and machine damage when handled by
unauthorized persons
Incorrect repair work and changes of the product may lead to significant
injuries and machine damage. The product warranty will be rendered
invalid if the unit is handled by unauthorized persons.
• Operating, maintenance, cleaning and repair work may only be carried
out by qualified personnel (in Germany see TRBS 1203).
Please observe the attached document "Warranty". In the event of any doubts
and/or problems, please contact your retailer or the manufacturer.
NOTICE
• Please also consult the operating instructions for the welding
components, such as power supply, compressed air line.
Cause
• Wrong torch mount used
• Mounting flange of the CAT2
defective
• Cable between CAT2 and cable
assembly is not connected
• Cable defective
• CAT2 switch housing defective
• Mounted load is too heavy
• Mechanical defect
• Mounting parts (mount etc.) not fixed
correctly
10 Troubleshooting
Solution
• Use correct torch mount
• Send in the CAT2 for service
reparation
• Connect cable
• Replace cable
• Send in the CAT2 for service
reparation
• Reduce mounted load
• Observe the data of the
manufacturer
• Send in the CAT2 for service
reparation
• Check the fastening of the
mounting parts
EN - 21