Binzel Abicor CAT2 Mode D'emploi page 37

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CAT2
1
16
15
14
1
Torch
2
Torch mount
3
Dowel screw M8
4
Helix cable
5
Connector housing
6
4 protection caps
Fig. 6
Mount CAT2 on the robot
2
13
12
7
Robot
8
Robot flange
9
4 cylinder screws
10 CAT2
11 Mount
1 Fasten torch mount (2) with dowel screw (3), washer (16) and nut (15) to
the mount (11).
NOTICE
• The fastening of the torch (1) depends on the respective torch type.
2 Fasten complete torch on torch mount (2).
3 Remove the protection caps (6). Insert an Allen key into the bore and
remove the protection caps (6).
NOTICE
• Ensure correct position of the connector housing.
 Fig. 5 Functional diagram on page EN-13
4 Mount CAT2 (10) on the robot flange (8) using four cylinder screws (9).
5 Reinsert the protection caps (6).
The following steps refer to the assembly of CAT2. For further assembly of the
CAT2 HL:
 6.1.1 CAT2 HL on page EN-17
3
4
5
11
10
12 Clamping ring
13 Cone clamping element
14 Cylinder screw M8
15 Nut
16 Washer
6 Putting into operation
6
7
8
9
EN - 15

Publicité

Table des Matières
loading

Produits Connexes pour Binzel Abicor CAT2

Table des Matières