Step 1 Remove Packaging - GE Monogram ZIC30GNNII Instructions D'installation

STEP 1 REMOVE PACKAGING

CAUTION:
THE REFRIGERATOR IS
TOP-HEAVY. BE CAREFUL WHEN MOVING.
• Cut bands and tape on the top and bottom
of packaging with a utility knife.
• Unfold the cardboard seams and remove the top
of the packaging.
• Slide the remainder of the box off of the appliance.
You can use a box cutter to cut the remaining
cardboard being VERY CAREFUL not to scratch
the appliance.
• Remove the Styrofoam supports from around the unit.
• DO NOT remove door band or lower EPS banded
part until unit is ready to go into enclosure.
• Cut EPS skid at the sides near the front from the back
of the unit.
• Push unit forward & remove rear portion of the EPS
skid.
• Carefully lower rear onto the floor.
• Lean unit back slightly & remove front portion of the
EPS skid.
• Discard all unused packaging materials appropriately.
• The unit can now be moved using an appliance hand
truck or rolled on a properly protected floor by 2
people.
• Leave any protective film on the refrigerator until
installation is complete.
Installation Instructions
13