Table des Matières
Publicité
• This appliance must be installed in locations where it can be overseen by trained personnel.
• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.
• Appliance shall not be tilted more than 10° for safe operation.
• An electrician must provide electrical service as specified in conformance with all local and national codes.
• This appliance must not be cleaned by water jet.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of
this appliance by a person responsible for its safety.
• Children should be supervised to ensure they do not play with the appliance.
• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with
a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.
These brewers must be connected to a cold water system with operating pressure between 20 and 90 psi (138
and 620 kPa) from a 1/2˝ or larger supply line. A shut-off valve should be installed in the line before the brewer.
Install a regulator in the line when pressure is greater than 90 psi (620 kPa) to reduce it to 50 psi (345 kPa).
The water inlet fitting is .75-11.5 NH (HOSE THREAD). For convenience an elbow adaptor is provided to convert
to a 1/4˝ flare fitting (3/8˝ flare on Twins). Bunn-O-Matic does not recommend the use of a reverse-osmosis or
deionized water supply to this equipment. REQUIRED: 1.25 gpm (4.73 lpm) flow rate from water supply line.
NOTE - Bunn-O-Matic recommends 3⁄8" copper tubing for all installations from the 1⁄2" water supply line. A tight
coil of tubing in the water line will facilitate moving the brewer to clean the counter top. Bunn-O-Matic does not
recommend the use of a saddle valve to install the brewer. The size and shape of the hole made in the supply
line by this type of device may restrict water flow.
This equipment must be installed to comply with the National Plumbing Code of Canada and the
Canadian Food Inspection Agency. For models installed outside Canada, you must comply with the
applicable Plumbing/Sanitation Code for your area.
Plumbing Hook-Up
1.
Remove the shipping cap from the fitting on the rear of the brewer.
2.
STANDARD MODELS: Securely attach adaptor elbow assembly to the .75-11.5 NH (HOSE THREAD) fitting
at the rear of the brewer.
TWIN MODELS: Securely attach the tube assembly (supplied in parts box) to water supply line. Securely
attach the elbow assembly to the .75-11.5 NH (HOSE THREAD) fittings at the rear of the brewer. Connect the
tube assembly to the elbows.
3.
Flush the water line and Securely attach it to the adaptor elbow.
4.
Turn on the water supply.
Connect sweetener line to fitting on back of brewer labeled "SWEETENER".
NOTE: Operating range for sweetener is 25-60psi, 35psi recommended.
CE Requirements:
PLUMBING REQUIREMENTS
OPTIONAL SWEETENER
7
36748.3 062111
Publicité
Table des Matières
