Table des Matières

Publicité

3

AVVIO

IMPORTANTE. Prima di utilizzare la scheda SIM nel
dispositivo, inserirla nel proprio telefono cellulare e disabilitare
la richiesta del codice PIN!
Se la scheda è protetta dal codice PIN non può operare con
il dispositivo
.
La capacità di memoria della scheda SIM deve essere
almeno di 128KByte.
Inserire la scheda SIM nel dispositivo
Attenzione! L'inserimento e la rimozione della scheda SIM
deve avvenire con l'apparecchio spento!
Collegare gli ingressi e le uscite di
lo schema di installazione (pagina 6) .
Posizionare l'antenna presente sul dispositivo come indicato
nel disegno 4 di pagina 3.
Collegare l'alimentatore alla rete elettrica.
Il LED di colore rosso, sul frontale del pannello, si accende
e comincia a lampeggiare, quando il dispositivo aggancia
la rete GSM si spegne il LED rosso e il dispositivo emette
un doppio bip; quando il dispositivo ha agganciato la rete
GSM, il LED di colore verde, presente sia sul retro che sul
frontale, si accende ed inizia a lampeggiare; il numero dei
lampeggi indica la potenza del segnale (1=segnale debole;
5=segnale eccellente).
Il dispositivo
Nota. Se il dispositivo non aggancia la rete GSM, il led rosso
continua a lampeggiare, mentre quello verde rimane acceso
ed il dispositivo emette un bip ogni 15 secondi.
IMPORTANTE. Prima di inviare i comandi SMS di
programmazione al dispositivo
in funzionamento normale e collegato alla rete GSM!
in accordo con
è pronto per funzionare.
, esso deve essere
Italiano
3 START UP
IMPORTANT. Before using the SIM card, insert it in your
mobile phone and disable the PIN code protection.
If the SIM is protected with the PIN code it can not operate
with
The required memory for SIM card must be 128KByte at
least.
Insert SIM card in the
.
Attention! Insert and remove SIM only when the device
is OFF!
Connect inputs and outputs of
installation diagram (see page 6).
Place the antenna of the device according to the drawing
4 at page 3.
Connect the power supply of the device to the main.
Red LED, on the front of the module, lights-ON and starts
flashing, when the device registers to the GSM network
the red LED switches-OFF and the devices emits a
double beep; after the device has been registered , green
LED, on the front and the back of the module, lights-ON
and starts flashing; the number of flashes indicate the
strength of the signal (1=weak signal; 5= excellent signal).
Note. If the device fails to register to the GSM network, red
LED continues flashing, while the green LED remains
continuously ON and the device emits a beep every 15
seconds.
IMPORTANT. Before sending the SMS programming
commands to
to the GSM network!
English
- 7 -
device.
device.
device is ready to operate.
it must be operating and connected
SIM
CARD
Min. 128KByte
according to the
Mi 2466

Publicité

Table des Matières
loading

Table des Matières