livin flame Duvin Instructions De Montage Et D'utilisation page 27

Resetting the Thermal Cut Out
3.2.36 The appliance is fitted with an Electronic Safety Control (E.S.). This is a safety device, which switches off
the fire if, for any reason, the appliance overheats, e.g. when covered. If the heater stops operating
while the flame effect continues working normally, this indicates that the E.S. Control is in operation.
The E.S. Control can only be re-set after the appliance has cooled down, and the appliance has been
reset. Re-setting of the E.S. Control proceeds is as follows:
3.2.37 Switch off the appliance (Manual On/Off switch) and leave it off for approximately 10-15 minutes.
3.2.38 Remove any obstruction to the fan heater outlet or fan blades etc. Make sure that the power supply is
disconnected with the plug socket outlet while doing this.
3.2.39 Switch on the appliance and the E.S. Control will be re-set.
3.2.40 Ensure that the appliance is functioning correctly. If the E.S. Control operates again, the appliance
should be checked by a competent electrician.
27