Checking For Blockages - shark Rocket HV300 Serie Instructions

MAINTAINING YOUR VACUUM
WARNING: Do not cut
anything but the hair,
fibers, or string that is
on the brushroll�
TIP: Ensure the bottom
of the floor nozzle is
completely sealed and
locked before using.
TIP: You do not need any
tools to open the floor
nozzle—just a coin.

CHECKING FOR BLOCKAGES:

HANDHELD AND WAND
1
Remove the wand from the handheld portion and check all
dust cup intake openings.
2 Remove the floor nozzle from the wand and check the
wand for blockages.
17
1-800-798-7398
STEP 1
STEP 2
BOTTOM OF FLOOR NOZZLE
1
Use a coin to unlock the three locks on
the bottom of the floor nozzle.
2 A portion of the base is removable to allow
for better access to the brushroll and
exposure to the airway. Shine a flashlight
from the bottom to check for possible
blockages in the airway.
STEP 3
STEP 4
3
Remove any string, carpet fibers, or
hair that may be wrapped around the
brushroll. There is a groove along the
brushroll that allows a pair of scissors to
cut across it to loosen up debris.
4 To re-assemble, replace base by lining it
up along the front of the nozzle. Rotate
down to snap into place until you hear a
click. Lock the three locks.
s h a r kc l e a n . c o m
18