Maintaining The Brushroll; Maintaining The Soft Roller; Checking For Blockages - shark FLEX HV392 Serie Instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MAINTAINING YOUR VACUUM - CONT�
WARNING: To reduce
the risk of shock and
unintended operation,
turn off power and
unplug unit before
servicing.
WARNING: When
cleaning brushroll, be
sure to not cut anything
other than hair, string,
fibers, or other debris.
TIP: If nozzle headlights
are flashing, then the
brushroll garage is not
completely closed. Ensure
the garage is completely
closed by pressing down
firmly on both sides.
NOTE: Heavy usage over
time may require minimal
upkeep in order to maintain
your vacuum's appearance.

MAINTAINING THE BRUSHROLL

1
Open the brushroll garage by sliding both release buttons
away from you, toward the back of the nozzle, then lifting
off the lid. Remove any string, hair, or debris that may be
wrapped around the brushroll by running scissors or the
lower corner of the lid along the guide on the brushroll.
2 Press down on both sides of the brushroll garage lid until it
clicks into place.
15
1-800-798-7398
STEP 1
STEP 2

MAINTAINING THE SOFT ROLLER

1
Open the brushroll garage by sliding both
release buttons away from you, toward the
back of the nozzle, then lifting off the lid. Lift
out the Soft Roller by the tab on the right
side. Clean off any string, carpet fibers,
or hair that may be wrapped around the
Soft Roller. Remove debris from the roller
housing.
2 Wash the Soft Roller as needed, using only
water. Air-dry completely for at least 24 hours
before returning it to the brushroll garage.
3 Reinsert the Soft Roller by sliding it into the
front of the nozzle until it clicks into place.
Close the brushroll garage by inserting the
tabs on the lid into the slots, then pressing
down on both sides of the lid until it clicks
into place.

CHECKING FOR BLOCKAGES:

HANDHELD, WAND, AND FLOOR NOZZLE
1
Remove the wand from the handheld
vacuum and check all intake openings on
the dust cup.
2
Remove the floor nozzle from the wand
and check the wand for blockages.
3
Tilt neck of floor nozzle back to straighten
the airway, then remove blockages.
s h a r kc l e a n . c o m
16

Publicité

Table des Matières
loading

Table des Matières