Getting Started; Unpacking Stream; Connecting The Power Supply; Inserting And Replacing The Battery In The Remote Control - Sonoro STREAM SO-411 Mode D'emploi

3

Getting started

3.1

Unpacking STREAM

1. Take STREAM out of the packaging and check whether STREAM or the
individual parts exhibit damages. If this is the case, do not use STREAM.
Should you detect any damage, contact your dealer or sonoro audio GmbH
customer support immediately.
2. Check to make sure that the delivery is complete (see chapter "Scope of
delivery").
3. Place STREAM at a suitable location. If you want to put your STREAM on a
natural wood surface, please make sure that it is suitable. On oiled and waxed
surfaces may possibly cause stains
4. Remove the protective film from the display.
3.2

Connecting the power supply

1. Insert the connector of the power adapter into the DC power input jack on
the back of STREAM.
2. Insert the power plug into a wall socket. STREAM is turned on.
Remove the protective cover before inserting the DC connector.
3.3

Inserting and replacing the battery in the remote control

1. Open the battery compartment cover on the back of the remote control by
turning it anticlockwise using a small coin.
2. Insert the supplied batteries (CR2025, 3 V) with the label (+) side up.
3. Close the battery compartment cover by turning the cover clockwise using a
small coin.
© sonoro audio GmbH 2022
GB
59