Quintezz Drive Control Mode D'emploi page 12

During moving, the speed of the car and the heading are shown.
Comfort display setting:
During moving and non-moving, the heading of the compass is shown in degrees.
If you have set the RLogic function to 'CITY' (see chapter 4.2.1 'RLOGIC...'), the 'C' of City is also shown on the display.
4.2.7 BELL / EXTRA SOUND
The following display appears once the bell / extra sound menu is accessed:
This option allows you to partially switch off the sound.
- Press the VOL + or VOL – button to switch the sound ON or OFF.
- To confirm this setting, press SAVE.
If you have selected OFF, the following sounds will not be audible:
- Start-up message: Fasten your seat belt, be careful.
- Warnings for cameras, in case you are NOT speeding.
4.2.8 LANGUAGE
The following display appears once the language menu is accessed:
- Press the VOL + or VOL – button to select the preferred language.
- To confirm this setting, press SAVE.
4.2.9 SN 0 DISPLAY
This is only shown whenever the Radar Detector function is de-activated. To activate the Radar Detector, it needs to have the
software enabled. To enable this software, you need to enter a secret code. The secret code consists of the last 4 digits of the serial
number.
-GB-7-