Performing Initial Start-Up; General Information - Siemens EQ900 Manuel D'utilisation

Inserting the water filter
ATTENTION!
Possible damage to the appliance
due to limescale build-up.
▶
Change the water filter in good
time.
▶
Change the water filter after
2 months at the latest.
▶
Observe the display messages.
Press ⁠ .
1.
Press "INTENZA filter" and follow
2.
the instructions on the display.
Changing or removing the water
filter
You can also operate your appliance
without a water filter.
Press ⁠ .
1.
Press "INTENZA filter".
2.
Press "Replace" or "Remove" and
3.
follow the instructions on the dis-
play.
Tips
¡ You should also change your wa-
ter filter for reasons of hygiene.
¡ With a water filter you need to de-
scale your appliance less fre-
quently.
¡ If you use a water filter, your coffee
will be more flavoursome.
¡ If your appliance has not been
used for a long time, for example if
you were on holiday, you should
rinse the water filter before use by
dispensing a cup of hot water.
¡ The water filter can be purchased
from retailers or customer service.
→ "Accessories", Page 15
6.4 Performing initial start-up
After connecting the appliance to the
power supply, configure the settings
for initial start-up. Initial start-up only
appears when switching on for the
first time.
Press to switch the appliance
1.
on.
Follow the instructions on the dis-
2.
play.
a The display will guide you through
the programme.
Notes
¡ If you want to set up Home Con-
nect now, follow the instructions in
the Home Connect app.
→ "Setting up Home Connect",
Page 23
¡ If "Demo mode" is selected, only
the display screens will work. You
cannot dispense a beverage or run
a programme.
6.5 General information
Please bear this information in mind
so that you can get the best out of
your appliance.
Notes
¡ The appliance has been pro-
grammed at the factory with stand-
ard settings for optimum operation.
¡ The grinder has been factory-set
for optimum operation. If coffee is
only dispensed drop by drop or is
too thin and with too little crema,
you can set the grinding level.
→ "Using electronic grinding level
adjustment eGrinder", Page 20
¡ During operation water droplets
may form at the ventilation slits
and on the lid of the tablet com-
partment.
¡ If you do not perform any actions
on the appliance for a certain
period, it will switch off automatic-
ally. You can change the duration
in the basic settings. → Page 25
first time en
17