Evercraft Air Tools 776-3702 Guide D'utilisation page 4

• Tighten the gun to the cup securely with the nut and fitting supplied.
• Be sure to have the proper air pres s ure at the gun to operate. Proper air pres s ure for this tool should not exceed 50 PSI.
• Adjust fluid control screw and spray width adjustment screw to your desired pattern before using on pro d uc t ion.
• Clean all parts after use.
Spray width adjustment screw.
Turn right for round, left for fan.
In normal use, the nozzle wings are
hor i z on t al as shown here. This pro v ides a
ver t i c al fan-shaped pat t ern which gives
max i m um, even ma t e r i a l coverage as the gun
is moved back and forth par a l l el to the sur f ace
being fin i shed.
776-3702
776-3702_Manual_091310.indd 4
FOR BEST PERFORMANCE, PLEASE BE SURE TO DO
THE FOL LOW ING BEFORE USING THIS TOOL
AdjusTmENTs
sprAyiNg
Spray pattern may be in f i n ite l y adjusted
from round to flat.
Fluid control screw.
Turn right to decrease flow, left to increase.
Set inlet pressure at no more than 50 PSI. For op t i m um
per f or m ance, some ma t e r i a ls may spray better at PSI
ratings below 50 PSI. If unsure, always test at PSI ratings before
using on final production. Try spray. If it is too fine, de c rease the air
pres s ure or open fluid control screw. If the spray is too thick, close the
fluid control screw. Reg u l ate the pat t ern width and repeat ad j ust m ent
of spray as needed.
4 09/13/10
9/13/10 4:49:39 PM