Publicité
Les langues disponibles
Les langues disponibles
Air
Length of Pipe (ft.)
Flow
CFM
50
100
3/4"
10
1/2"
3/4"
20
3/4"
3/4"
30
3/4"
1"
40
1"
50
1"
70
1"
Never mount oil and water extractor on or near the air com pres sor.
During compression, air temperature is greatly increased. As the air cools down to room tem p er a t ure, moisture condenses in the air line, on
its way to the spray gun. Therefore, always mount the oil and water extractor at a point in the air supply system where the compressed air
temperature is lowest.
Drain air lines properly.
Pitch all air lines back towards the com p res s or so that con d ensed mois t ure will flow back into the air receiver where it can be drained off.
Each low point in an air line acts as a water trap. Such points should be fitted with an easily accessible drain. See diagram above.
This spray gun is rugged in construction, and is built to yield exceptional value. The life of this product and the efficiency of its
operation depend upon a knowledge of its construction, use and maintenance.
Air Inlet
Atomization
Pressure
Gauge
Fluid
Control
Screw
Oil and Water
Extractor
Fluid
Siphon
Cup
Air Hose
SIPHON FEED CUP HOOKUP
Air pressure for atomization is reg u lat ed at
ex t rac t or. Amount of fluid is adjusted by fluid
control screw on gun, viscosity of paint, and
air pressure.
Air Inlet
Fluid
Control
Screw
Fluid
PRESSURE FEED TANK HOOKUP
(Single Regulator)
Air pressure for atomization is regulated
at extractor, fluid pressure at tank regulator.
776-3702
776-3702_Manual_091310.indd 3
Air supply
150
200
3/4"
3/4"
3/4"
1"
1"
1"
1"
Drain
1"
1"
1"
1"
1-1/4"
1-1/4"
TypEs OF iNsTAllATiON
Air Inlet
Fluid Control
Screw
Fluid Siphon Cup
PRESSURE FEED CUP HOOKUP
For fine finishing with limited spraying. Air pressure
for atomization is reg u l at e d at ex t rac t or; fluid
pressure at cup regulator. For heavy fluids and
internal mix nozzle spraying, fluid adjusted by
control screw on gun.
Air
Extractor
Pressure
Main
Tank
Line
Outlet
Pitch pipe back
toward air receiver
Compressor Unit
Oil and Water Extractor should be at least 25 ft.
from the compressor, farther if possible.
Atomization
Pressure
Gauge
Oil and Water
Extractor
Air Hose
Air Inlet
Fluid
Control
Screw
Air
Fluid
PRESSURE FEED CIRCULATING HOOKUP
For fine finishing with limited spraying. Air pressure for atomization is reg u l at e d at
ex t rac t or; fluid pressure at cup regulator. For heavy fluids and internal mix nozzle
spraying, fluid adjusted by control screw on gun.
3
Install drain at
each low point
Oil & Water
Extractor
Drain
25 Feet or More
Air Inlet
Supply
Fluid
Control
Pressure
Screw
Tank
Fluid
PRESSURE FEED TANK HOOKUP
(Double regulator)
Air pressure for atomization and fluid supply is
regulated by two individual air regulators on tank.
Fluid
Regulator
Extractor
09/13/10
9/13/10 4:49:38 PM
Air
Fluid
Publicité
