Charging The Powerstation - Berger Powerstation BPS600 Manuel D'utilisation

GB

4.2 CHARGING THE POWERSTATION

You can use the following methods to charge the powerstation. 1:
1. use the standard mains adapter, to do this connect the mains cable to the adapter, on the
other side connect the DC plug to the input charging socket of the powerstation, then plug
the 230 V mains plug into a 230 V household socket.
+ =
2. charging with the car charging cable: after you have started the car, plug the 12 V plug
into the 12 V socket of the car, the other side is connected to the input socket of the power
station.
3. solar charging - if you use a solar panel to charge the power station, connect the sup-
plied adapter cable to the solar cable of the solar panel, then connect the other side of the
adapter to the input connector of the power station (please make sure that the maximum
voltage of the solar panel does not exceed 18 V).
NOTE:
1. our standard power bank can only be used in our power station, please do not use it on
other devices and keep it away from rain.
2. when using car charging and solar charging, please make sure the positive and negative
connections are correct.
3. if the portable power station is not used for a long time, the built-in battery will dischar-
ge and may be damaged. Therefore, please charge the power station every 3 months.
18