Operating Instructions And Precautions; Use Of The Alternating Current (Ac) Outputs - Berger Powerstation BPS600 Manuel D'utilisation

GB

4. OPERATING INSTRUCTIONS AND PRECAUTIONS

To ensure safe transportation, the power station is not fully charged, please fully charge
the power station before use. If you want a quick charge, please use our standard original
mains adapter for charging, or use an 18 V / 100 W solar panel for charging. To ensure
safety, please only use our standard charger. Please disconnect the charger when the Power
Station is fully charged.

4.1 USE OF THE ALTERNATING CURRENT (AC) OUTPUTS

Please read the following instructions before use:
Make sure that the input voltage and frequency of the load matches the BPS600.
Make sure that the rated power of the load is less than 600W, it is better if the rated power
does not exceed 80%.
* Failure to do so may result in damage to the Power Station or shutdown.
* If the power of your connected consumer is higher than 600W, please choose another
Powerstation with higher power.
Note: Some appliances, when switched on, have a much higher power than the rated pow-
er, e.g. the starting current of appliances with inductive load is usually 3-8 times higher than
the rated power, the starting power of energy saving lamps is dozens of times higher than
their rated power. If the starting power is higher than the peak power of the Powerstation,
the overload protection triggers and switches off the Powerstation.
The Powerstation is equipped with overload, short-circuit and overtemperature protection.
If the following conditions are met, the Powerstation switches off the sockets:
If the load power of the appliance is higher than the rated power of the Powerstation.
If there is a short circuit in the connected load.
If the temperature in the appliance is too high.
If the battery voltage is too low.
17