KOBE CH00 Série Manuel D'installation Et Mode D'emploi page 15

Duct Cover Installation
8. Use 6" round steel pipe for 30" and 36" models or 8"
round steel pipe for 42" and 48" models (follow
building codes in your area) to connect the exhaust
on the hood to the ductwork above. Use duct tape
to make all joints secure and air tight. Refer Figure
13. Slide the duct cover onto the hood.
9. Use 3/16" x 3/8" screws (included) to attach duct
cover to hood.
Install Accessories
10. Attach oil tunnel. Refer to Figure 14.
11. Refer to Figure 15.
hood. Push the baffle filter upward.
forward. Pull downward.
12. Repeat until all baffle filters and spacers are resting
against oil tunnel. Refer to page 22.
Final Assembly
13. Turn power ON in control panel. Check all lights and
fan operation.
14. Make sure to leave this manual for the homeowner.
Slide the baffle filter into the
Fit into place.
Figure 13
Figure 14
Slide
Figure 15
13