KOBE CH00 Série Manuel D'installation Et Mode D'emploi page 14

6. For safety purpose, pre-drilled mounting holes are
provided through the back of the hood. For a more
secure installation, use as many mounting holes as
needed to secure from the inside of hood (screws
included).
CAUTION: MAKE SURE HOOD IS SECURE
BEFORE RELEASING.
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD
MUST BE PROPERLY GROUNDED. MAKE SURE
THIS IS DONE BY SPECIALIZED ELECTRICIAN IN
ACCORDANCE WITH ALL APPLICABLE NATIONAL
AND LOCAL ELECTRICAL CODES.
CONNECTING WIRES, SWITCH POWER OFF AT
SERVICE PANEL AND LOCK SERVICE PANEL TO
PREVENT POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
7. Connect the electrical wires.
-
Connect three wires (black, white and green) to
house wires and cap with wire connectors.
Connect according to color: black to black, white
to white, and green to green as shown on Figure
12.
-
If necessary to hide the electrical wire
connections, push wires back into the wiring box.
Access the wire connections underneath the
hood. To prevent any damage, make sure wires
do not slip between motor or any moving parts.
Figure 12
BEFORE
12