KOBE CH00 Série Manuel D'installation Et Mode D'emploi page 13

Model No.: CH0030DC-12 / CH0036DC-12 / CH0042DC-12 / CH0048DC-12
Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.
Decide the location of the venting pipe from the hood
to the outside. Refer to Figure 9.
A straight, short venting run will allow the hood to
perform more efficiently.
Try to avoid as many transitions, elbows, and long run
as possible. This may reduce the performance of the
hood.
Temporarily wire the hood to test for proper operation
before installing.
Important: Peel protective film off the hood and
the duct cover (if any).
If necessary, prepare back wall frame with cross
framing lumber for secure installation.
Using references on Table 2 and measurements on
page 23-24, decide the level of the lumber. Refer to
Figure 10.
Hood Installation
CAUTION: If required to move the cooking
range to install the hood, turn off the power on an
electric range at the main electrical box. SHUT OFF
THE GAS BEFORE MOVING A GAS RANGE.
1. (This step only applies to 42" and 48" models.)
Attach exhaust plate on hood with four (3/16" x 3/8")
screws (included). Shown in Figure 11.
2. If necessary, remove the rubber stand on the back
of the hood.
3. Use twelve (3/16" x 3/8") screws (included) to attach
the two hood-mounting brackets (included) to the top
of the hood.
4. Using references in Table 2 and Measurements and
Diagrams on pages 23-24, mark the leveling point of
the hood. Position six mounting screws (included) on
the wall, leaving 1/8" away from the wall.
5. Align hood-mounting bracket to the six screws on the
wall and hook hood into place. Tighten screws to
secure hood to the wall.
CH00 SERIES – WALL MOUNT INSTALLATION
***This installation required to have Duct Cover
Figure 9
Figure 10
Figure 11
11