Robert Juliat 1011+ F Dossier Technique page 10

CONNECTIONS.
e
d
DESCRIPTION.
+
A 1011 F Cold restrike & manual shutter version.
C Lighting unit's power cable.
Cable H07 RN-F 4G 1,5mm
with a 3 point + E, P17 male plug.
e 10A. EEC - Female power socket.
B Power supply unit (P.S.U.)
Refer to page 27.
Before connecting to the mains.
- Check power conformity; P.S.U. power 1 conform with lamp power : 1200W.
- Check voltage conformity with the mains: 230V/50Hz or 245/50Hz or 208/60Hz.
•
Untighten the screw 3 .
•
Turn the switch 4 to select the appropriate voltage.
•
Then tighten the screw 3 .
Lighting unit / Power supply connection.
- Connect the power supply cable C by passing it inside the yoke.
- Leave a little slack and then block the cable C into the lock d .
- Place the lamp into position - refer to page 12.
- Connect the cable 2 to the mains.
10
robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle phone: 33 (0)3.44.26.51.89 - fax: 33 (0)3.44.26.90.79 - www.robertjuliat.fr
TECHNICAL FILE
1200W HMI FOLLOW SPOT
COLD RESTRIKE
C
2
2 length 3m fitted
230V.
50Hz
208V.
60Hz
B
Power supply unit
(P.S.U.)
1
CAUTION - For your security !
- Never open the lantern's bonnet when the
lighting unit is on.
- Do not change the safety switches.
- Never connect to a dimmable channel.
- Use only when lamp in place.
1011+ F & 1011+CF
VALID SINCE : 20.10.03
245V.
50Hz
3
4