Fein GRIT GKS75-1,5KW Notice D'instruction D'origine page 9

Original Instructions.
en
Symbols, abbreviations and terms used.
The symbols in the Instruction Manual and on the machine shall aide in directing your attention to possible hazardous
situations when working with this machine.
Symbol, character Explanation
Do not touch the rotating parts of the machine.
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction Manual and the General Safety
Instructions.
Use eye protection during operation.
Use ear protection during operation.
Use a dust mask during operation.
Use protective gloves during operation.
Danger warning
Confirms the conformity of the machine with the directives of the European Community.
Worn out machine and other electrotechnical and electrical products should be sorted sepa-
rately for environmental-friendly recycling.
Character Unit of measure-
ment, international
n /min, min
r/min
n /min, min
0
r/min
P
W
1
P
W
2
U
V
f
Hz
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
For your safety.
Do not use this machine before you have thor-
oughly read and completely understood theseop-
erating instructions, including the figures,
specifications, and safety regulations.
Please also observe the relevant national industrial safety
regulations (e. g. in Germany: BGV A2, BGR 500).
Non-observance of the safety instructions in the said
documentation can lead to an electric shock, burns
and/or severe injuries.
This Instruction Manual should be kept for later use and
enclosed with the power tool, should it be passed on or
sold.
Unit of measure-
ment, national
-1
, rpm, rpm
-1
, rpm, rpm
W
W
V
Hz
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2 2
min, m/s
Explanation
Rated speed
No-load speed
Power input
Output
Rated voltage
Frequency
Basic and derived units of measurement from the
international system of units SI.
Intended use of the power tool:
Stationary grinder to grind of metal materials using man-
ufacturer approved grinding belts.
Special safety instructions.
Wear personal protective equipment. Depending on
application, use face shield, safety goggles or
safety glasses. Where appropriate, wear dust
mask, hearing protectors, gloves and workshop
apron capable of stopping small abrasive or work-
piece fragments. The eye protection must be capa-
ble of stopping flying debris generated by various
operations. The dust mask or respirator must be
capable of filtrating particles generated by your opera-
tion. Prolonged exposure to high intensity noise may
cause hearing loss.
en
9