Connecting The Wireless Camera And Screen - Conrad 75 18 00 Notice D'emploi

7.2 Connecting the wireless camera and screen

Make sure that the plug and socket of the connection cable are not exposed to
humidity. Plugs and sockets may only be used indoors. The plug connections must
therefore be routed into in a dry room (for installation in outdoor areas or in damp
rooms).
• Connect the low voltage plug of the supplied mains adapter with the "DC IN 5 V/DC" (7) power sock-
et on your wireless camera.
• Plug the mains adapter into a suitable mains socket.
• If required, connect the video and audio input of another screen to the "AV-OUT" (30) socket (the
respective adapter cable is included; 3.5 mm jack to RCA).
• Connect the low voltage plug of the included mains adapter with the "DC IN 5V" (31) power connec-
tion on your wireless camera.
8. Start-Up
• Insert an SD card into the Micro SD card slot (27). Supports SD cards of up to 2 GB and SDHC cards
of up to 32 GB.
• Turn the screen on by pressing the ON/OFF button (19).
• Perform the connection search (for this, observe chapter: "10.1 Camera Setup Menu" > "c) Pairing").
9. Inserting the batteries in remote control
• Pull the battery compartment at the rear out downwards while pressing down the battery compart-
ment catch with a fingernail.
• Insert a 3V coin cell battery correctly (Type CR2025) into the battery holder.
• Push the battery holder with the inserted battery back into the remote control.
34