Overview; Operating Positions - Bosch MUM52 Serie Mode D'emploi

Overview

en
Overview
Please fold out the illustrated pages.
Fig. A:
Base unit
1 Release button
2 Swivel arm
"Easy Armlift" function to support the
upward movement of the arm (see
"Work positions").
3 Rotary switch
When the appliance has been switched
off (position P), the appliance runs
automatically to the optimum position for
changing the tools.
MUM52..:
P = Stop
M = Instantaneous switching at
maximum speed, hold switch for
required blending duration.
Settings 1-4, Operating speed:
1 = low speed – slow,
4 = high speed – fast.
MUM54../MUM55../MUM56../MUM58..:
P = Stop
M = Instantaneous switching at
maximum speed, hold switch for
required blending duration.
Settings 1-7, Operating speed:
1 = low speed – slow,
7 = high speed – fast.
4 On/Off display
(MUM54../55../56../58..)
Is lit while the appliance is operating
(rotary switch on M or 1-7). Flashes
if the appliance has been operated
incorrectly, the electronic fuse has
tripped or the appliance is defective –
see section "Troubleshooting".
5 Drive cover
To remove the drive cover, press on the
rear area and remove cover.
6 Drive for
– Continuous-feed shredder and
– Citrus press (optional accessory*).
When not in use, attach the drive cover.
7 Drive for tools (stirrer, whisk, kneading
hook) and mincer (optional accessory*)
20
123_MUM58xxx_8001027204.indb 20
8 Blender drive cover
9 Drive for blender (optional accessory*)
When not in use, attach the blender
drive cover.
10 Cord store
MUM52../MUM54../MUM58..:
Stow the cord in the cord store
MUM55../MUM56..:
Automatic cord winder
Bowl with accessories
11 Stainless steel stirring bowl
12 Lid
Tools
13 Stirrer
14 Whisk
15 Kneading hook with dough deflector
16 Accessories bag
For storage of the tools and cutting
discs.
Continuous-feed shredder
17 Pusher
18 Cover with filling shaft
19 Cutting discs
a Reversible slicing disc – thick / thin
b Reversible shredding disc –
coarse / fine
c Grating disc – medium-fine
20 Disc holder
21 Housing with outlet opening
Blender*
22 Blender jug
23 Lid
24 Funnel
* If an accessory is not included in the
product package, it can be purchased via
the trade or customer service.

Operating positions

Fig. B:
Attention!
Before operating the appliance, attach the
tool / accessory to the correct drive and
in the correct position and place in the
operating position according to this table.
The swivel arm must be engaged in every
operating position.
26.11.2015 16:10:30