Operating Instructions - Haussmann Xpert BS1200 Manuel De L'utilisateur

The HAUSSMANN XPERT 12" band saw features welded
steel frame construction and a granite table surface to
insure durability. It is designed for cutting hard and soft
woods, as well as nonferrous metals and plastics. Saw
includes stand and rip fence. A quick tensioning and
release handle makes changing the blade speed quick
and easy. Saw also features 2 ½" dust collection ports,
blade tensioning window and work lamp.
SAFETY PRECAUTIONS
WARNING
Always observe the following safety precautions.
• Whenever adjusting or replacing any parts on the band
saw, turn switch off and remove plug from power source.
• Make sure the blade guides are positioned correctly.
• Use the appropriate blade for the workpiece that is
being cut.
• Use a sharp blade. Replace dull blades or blades which
are missing teeth.
• Make sure the blade is tensioned properly and going in
the right direction.
• Use the proper blade speed for the work.
• For optimum performance, do not stall the motor or
reduce the speed. Use the proper feed pressure.
• Secure the workpiece in a stable position.
• Check that all guards are attached.
• After turning the switch on, let the blade come to full
speed.
• Keep hands away from the blade and all moving parts.
• Always wear eye protection or face shield.
• Always stop the band saw before removing scrap
pieces from table.
• Never attempt to saw stock that does not have a flat
surface, unless a suitable support is used.
• Always hold material firmly and feed it into the blade at
a moderate speed.
• Always turn off the machine if the material is to be
backed out of an uncompleted cut.
• Make sure that the blade tension and blade tracking are
properly adjusted.
• Make "relief" cuts before cutting long curves.
• Release blade tension when the saw will not be used
for a long period of time.
WARNING
Before starting check if any part of your band saw is
missing, malfunctioning, has been damaged or broken,
such as the motor switch, or other operation control, a
safety device or the power cord, turn the band saw off and
unplug it until the particular part is properly repaired or
replaced.

OPERATING INSTRUCTIONS

ON/OFF SWITCH
Refer to Figure 10.
The ON/OFF switch is located on the top of the motor. To
turn the machine ON, pull the switch to the up position. To
turn the machine OFF, push the switch to the down posi-
tion.
NOTE: When the machine is not in use, the machine
should be locked in the "OFF" position to prevent unau-
thorized use.
• To lock the machine, turn the switch to "OFF" position.
Pull the key out. The switch cannot be turned on without
the key.
• If the key is removed when the switch is at the "On"
position, the switch can be turned off but cannot be
turned on again.
• To unlock, place the key into the slot on switch unit it
clicks into place.
Figure 10 - On-Off Switch
ADJUSTING THE BLADE TENSION
Refer to Figure 11.
The blade tracking, tension and blade guides have been
properly adjusted at the factory. However, the adjustments
may change while the saw is in transit. It is recommended
to verify these adjustments before operating saw.
• To loosen the tension of the blade, turn the blade
tension knob counter clockwise and the tension indicator
will be lower. To tighten the tension of the blade, turn the
tension knob clockwise, and the tension indicator will rise
(see Figure 11).
23