Haussmann Xpert BS1200 Manuel De L'utilisateur page 21

WARNING
The band saw is designed to be safely assembled by at
least two people working together.
DO NOT attempt to run or use this machine until all parts
are assembled and working properly to avoid injury.
STAND ASSEMBLY
Refer to Figure 2.
• Check contents against the parts list.
• Fasten front panel on to paired legs, using hex carriage
bolts, washers and hex nuts. Do not fully tighten.
• Fasten side panel on to front panel/paired legs
assemblies using remaining hex carriage bolts, washers
and hex nuts.
• Fasten the front and side beams on the paired legs with
hex carriage bolts, washers and hex nuts.
Figure 2
• Set stand in an upright position, ensuring that the holes
on the top edge of the panels line up sufficiently to allow
hex head screws to pass through. Fully tighten the hex
carriage bolts and hex nuts.
• Press rubber feet on to the end of stand legs.
WARNING
To avoid back injury, get help lifting the band saw. Bend
your knees, lift with your legs, not your back.
• With assistance lift band saw and carefully position in
place on top of stand.
• Fix in position using hex head screw, through washer,
band saw base, stand, and washer. Secure on under
side with hex nut. Repeat procedure for all four corners
before tightening fully.
NOTE: Standard hardware items are available locally.
MOUNTING THE GRANITE TABLE
Refer to Figure 3.
• Slide Blade through blade slot in the table.
• Place granite table on table mount.
Figure 3
• Install table locking screw into the table mount.
• Securing table by tightening the table locking screw.
Figure 4
Table Locking Screw
Centering Granite Table
Move the table sideways as required, until the saw blade
runs through the center of the table insert.
• If moving the table is not enough to center the table,
loosen the four nuts holding the table and move the
table sideways to place the table in the center.
• Re-tighten nuts and recheck the saw blade position.
20