Haussmann Xpert BS1200 Manuel De L'utilisateur page 22

SETTING TABLE SQUARE TO SAW BLADE
Refer to Figure 5.
Place a suitably sized square against the saw blade on
right and left position. If the table requires adjustment,
proceed as follows:
• Using a wrench, release the hex nut on the frame (see
Figure 5).
• Place the wrench on the hex bolt and adjust until the
table is square to the saw blade (See Figure 5).
• Tighten the hex nut and recheck the saw blade and the
table for squareness.
• Lock the table into position and check that the indicator
reads zero degree on the side of lower table trunnion.
• Loosen the screw securing the indicator and reset if
necessary to give zero degree reading.
Figure 5
SETTING TABLE SQUARE FRONT AND
BACK OF BLADE
Refer to Figure 6.
Place a suitably sized square against the saw blade on
back and force position. If the table requires adjustment,
proceed as follows:
• Using a wrench, release the flange nut on the lower
table mount (see Figure 6).
• Place the M5 hex wrench on the hex socket set
screw and adjust until the table is square to the saw
blade on the front and back position (see Figure 6).
• Tighten the flange nut and recheck the saw blade and
the table for squareness.
Hex Nut
21
Figure 6
ATTACHING DUST BAG
Refer to Figure 7.
• Place dust bag clamp over dust bag sleeve
• Slide sleeve with clamp and dust bag over dust chute.
• Secure dust bag in position. Rotate the handle on the
clamp to adjust the clamp size so it can slide over the
dust chute. Press the handle to tighten the clamp.
• The dust bag should be secured on the dust chute
now.
Figure 7
Dust Collection Bag
Hex Nut
Clamp
Dust Port