Troubleshooting - Napoleon ROGUE Serie Manuel Du Propriétaire

Masquer les pouces Voir aussi pour ROGUE Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting

Lighting problems
• Main, rear or side burners will not light with the igniter, but will light with a match.
• Burners will not cross light each other
Possible causes
JETFIRE
TM
outlet is dirty or clogged
Dirty or corroded cross light brackets.
Dead battery, or installed incorrectly.
Loose electrode wire, or switch terminal wires.
Lifting flames on burner.
Infrared burner flashes back.
• During operation the burner abruptly makes a loud whoosh sound, followed by a continuous blow-torch type sound and
grows dim.
Possible causes
Ceramic tiles overloaded with grease drippings and build-
up. Ports are clogged
Burner overheated because inadequate ventilation. Too
much grill surface covered by griddle or pan.
Leaking gasket surrounding the ceramic tile, or a weld
failure in the burner housing.
Leaking gasket surrounding the ceramic tile, or a weld
failure in the burner housing.
1
2
3
Napoleon.com | Rogue Series Grills
Solution
Clean JETFIRE
TM
outlet with a soft bristle brush.
Clean or replace as required.
Replace with premium heavy- duty battery.
Check electrode wire is firmly pushed onto the terminal on the
back of the igniter. Check the lead wires from the module to the
ignition switch (if equipped) are firmly pushed onto their respective
terminals.
Close air shutter according to Maintenance Instructions-Combustion
Air Adjustment section in this Owner's Manual.
IMPORTANT! This must be done by a qualified gas installer.
Solution
Turner burner OFF and allow to cool for at least 2 minutes. Reignite
burner and burn on HIGH for at least 5 minutes, or until the
ceramic tiles are evenly glowing red.
Ensure no more than 75% of the grill surface is covered by objects
or accessories. Turn burner OFF and allow to cool for at least 2
minutes. Reignite.
Allow burner to cool and inspect very closely for cracks. Contact
your authorized Napoleon dealer to order replacement burner
assembly if any cracks are found.
Contact your authorized Napoleon dealer for instructions on
ordering a replacement burner assembly.
WE WANT
TO HELP!
Napoleon is here to
ensure your grilling
experience is
memorable. Contact
us if you require
additional help.
REGISTER
YOUR GRILL!
Register your grill! Go
to Napoleon.com or
your Assemby Guide
for replacement parts
instructions.
19
Troubleshooting |

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rogue rxt525pss-1Rogue rxt625sibpss-1

Table des Matières