Husqvarna TE 250 2009 Livret D'utilisation Et D'entretien page 146

MUM2-250_310_450_510_2009_GB
BRAKE PADS REMOVAL
- Remove springs (1).
- Remove pins (2).
- Remove pads.
CAUTION!
Don't operate the brake lever or pedal
while removing the pads.
1
54
21-05-2008 9:37 Pagina 54
PADS WEAR (TE-TC-TXC)
Inspect pads for wear.
Service limit " A" is: 3,8 mm (0.15 in.).
If service limit is exceeded, always replace the pads in pairs.
SMR
FRONT
TE-TC-TXC
FRONT
2
2
1
REAR
PADS WEAR (SMR)
a) In front: thickness "A" must never be lower than the one
pointed out by the wear control notches.
b) At the back: thickness "A" must never be lower than 3,8 mm.
If service limit is exceeded, always replace the pads in pairs.
TE-TC-TXC