Husqvarna TE 250 2009 Livret D'utilisation Et D'entretien page 142

MUM2-250_310_450_510_2009_GB
REMOVING THE FRONT WHEEL
Set a stand or a block under the engine and see that the front
wheel is lifted from the ground. Loosen the bolts (1) holding the
wheel axle (2) to the front
fork stanchions.
SMR: remove the two screws (A) and the brake caliper.
Hold the head of the wheel axle (2) in place, unscrew the bolt
(3) on the opposite side; draw the wheel axle out.
50
21-05-2008 9:37 Pagina 50
NOTES
Do not operate the front brake lever when the wheel has been
removed; this causes the caliper piston to move outwards. After
removal, lay down the wheel with brake disc on top.
TE-TC-TXC
2
TE-TC-TXC
1
1
3
SMR