Husqvarna TE 250 2009 Livret D'utilisation Et D'entretien page 123

MUM1-250_310_450_510_2009_GB
REPLACEMENT OF COOLING FLUID
Place a vessel on the R.H. side of the cylinder, under the coolant
drain screw (1).
FIRST remove the screw (1) then SLOWLY open the R.H. radiator
cap; slope the motorcycle on the right side to drain the coolant
easily in the vessel. Reassemble the screw (1).
Pour the necessary quantity of coolant in the radiator then warm
up the engine in order to eliminate any possible air bubble.
1
21-05-2008 9:29 Pagina 31
Periodically check the connecting hoses (see "Periodical mainte-
nance card"): this will avoid coolant leakages and consequent
engine seizure: If hoses (A) show cracks, swelling or hardenings
due to sheats desiccation, their replacement shall be advisable.
Check the correct tightening of the clamps (B).
A
B
B
A
31