Lindemann LIMETREE BRIDGE Mode D'emploi page 23

WLAN operation
To run the device in a WLAN network environment, it must
WLAN
be logged in there. The easiest way is the "push-button con-
nection" via WPS. Turn on the network bridge as described above. Fix the
antenna. Wait until the sample rate LED lights up. Now press the WPS
button on your router until its WLAN LED starts flashing. Then press the
WPS miniature button on the network bridge until its WLAN LED starts
flashing as well (may vary depending on your router type). After a short
while the successful log-on will be confirmed by the sample rate LED
flashing green. If it lights up red, the above procedure must be repeated.
With the LINDEMANN app you can also manually enter the security key
of your router. In this case the network bridge must be connected to the
network via a LAN cable first. Now click on Settings/Network Assistant/
WLAN/manual in the app and enter all your router data here.
Connect the Limetree BRIDGE with your D/A converter.
Open the LINDEMANN app on your smartphone/tablet. Select the net-
work bridge as your playback device under "Devices" and you're done!
The LAN cable is now no longer needed. Select the desired source and
start browsing.
Bluetooth operation
The Limetree BRIDGE has a Bluetooth function which allows
Bluetooth
wireless music playback e. g. from smartphones or tablets.
Note: For a Bluetooth audio transmission from a mobile terminal to
the Limetree BRIDGE the mobile device must support the A2DP Blue-
tooth audio transmission protocol.
To connect your mobile device with the Limetree BRIDGE, select the
"Bluetooth" tab in the LINDEMANN app. Now open the Bluetooth settings
on the corresponding mobile device and establish a connection with the
the Limetree BRIDGE.
You may now close the LINDEMANN app. To return to network oper-
ation, simply cut the connection with the Limetree BRIDGE on your
mobile device.
EN 23
TOP h TOP h