Functional Description - Lindemann LIMETREE BRIDGE Mode D'emploi

FUNCTIONAL DESCRIPTION

Limetree
on
1
1. The toggle switch on the front of the network bridge has two func-
tions: push it up briefly to turn the unit on. A second short push will
turn the unit off again. To switch the output mode of the digital outs,
press and hold the switch in the upper position for three seconds.
Note: after turn-on the device will need some time to boot. The unit
is ready for use when the Sample Rate LED is lit. After turn-off the
Power LED will flash until the unit has shut down.
Bridge
SR Mode
2 3
2. Function indicator of the input signal sampling rate.
The color of this LED will change along with input
signal sampling rate.
Green PCM 44.1/48 kHz
Cyan PCM 88.2/96 kHz
Blue PCM 176.4/192 kHz
White PCM 352.8/384 kHz
Yellow DSD 64
Orange DSD 128
Purple DSD 256
3. Output mode function indicator: when the LED is dark,
the device is in Mode 1 at 88.2/96 kHz. When lit yellow,
the device is in Mode 2 at 176.4/192 kHz.
EN 19
TOP h TOP h