GETINGE Arjohuntleigh Bari-Breeze Notice D'utilisation page 12

Polyurethane cells approximately 250mm (10") high
Cells
providing support to the patient.
Manufactured from material to reduce accidental
Tubeset
kinking.
Located at the pump end of the tubeset is a specially
Tubeset Connector/CPR
designed twin snap lock connector. This design helps
prevent accidental disconnection of the mattress from
the pump. Releasing the connector allows rapid
deflation of the mattress in order to facilitate CPR.
For additional access or to facilitate transfer, the side
bolsters and base air pad can be deflated by removing
the air plug.
The mattress is totally enclosed in a double zipped
Cover
cover. The top and sides of the cover are constructed
from a two-way stretch and water resistant material,
which is vapour permeable for maximum patient
comfort. The base of the cover is constructed from a
tough abrasion resistant material and is fitted with bed
attachment straps.
A 50 mm (2") thick sub-mattress made of a single air-
Base Air Pad
filled cell enclosed in the base to support the patient in
the event of loss of air pressure in the mattress.
Two side air bolsters which provide optimal support and
Bolsters
comfort for the patient particularly when the system is
operating in mode.
Turn
The air plug is used to deflate both the side bolsters and
Air Plug
base air pad. It is located close to the tubeset/pump
connector.
3