Publicité
Les langues disponibles
Les langues disponibles
Mode (pg. 8).
2. Check that the batteries still have adequate power levels.
Always replace all batteries at the same time.
Photos Do Not Capture Subject of Interest
1. Try to set your camera up in an area where there is not a
heat source in the camera's line of sight.
2. In some cases, setting the camera near water will make
the camera take images with no subject in them. Try
aiming the camera over ground.
3. Try to avoid setting the camera up on small trees that are
prone to being moved by strong winds.
4. Remove any limbs which are right in front of the camera
lens.
AIM/Status LED Flashes/Doesn't Flash
1. When the camera's Power Switch is set to AIM (Setup
Mode), an AIM/Status LED on the front of the camera will
flash when it senses motion. This is for setup purposes
only and will help the user position and aim the camera
to check the area of detection/coverage.
2. During use, the LED will not flash when the camera takes
an image. This is to help keep the camera hidden from
game.
LCD Screen Issues
1. LCD screen powers on but no text is present.
a) After moving the Power Switch from OFF to AIM or
ON" make sure that the switch is correctly in position to
ensure the proper mode (avoid positions "between" two
modes).
b) Do not move the switch directly from ON to AIM-
always move the switch all the way down to OFF first,
then back up to AIM.
Camera won't retain settings
Make sure that you have been saving the changes to any
settings that you made while in Setup Mode, by pressing
the OK key after changing the setting. If you don't save
your new setting after changing it, the camera will
continue to use the original default setting for that item/
option.
16
Publicité
