Publicité
Les langues disponibles
Les langues disponibles
Using the adjustable web belt: Push one end of the belt
through the two brackets on the back of the Tasco Trail
Camera (Fig. 12). Thread the end of the strap through the
buckle. Fasten the belt securely around the tree trunk by
pulling the end of the strap firmly so there is no slack left.
Note: it is not possible to use a cable lock (in the upper part of
the bracket) and the web belt at the same time.
Using the tripod socket: The camera is equipped with a
socket at the bottom end to enable mounting on a tripod or
other mounting accessories that use a standard1/4-20 thread.
Sensing Angle and Distance Test
To test whether the Tasco Trail Camera can effectively monitor
the area you choose, this test is recommended to check the
sensing angle and monitoring distance of the Tasco Trail
Camera. To perform the test:
• Switch the camera's Power Switch to AIM. You can
ignore the Setup display, no need to change any settings
(provided you already set the time/date and other Setup
Mode options in advance).
• Make movements in front of the camera at several
positions within the area where you expect the game or
subjects to be. Try different distances and angles from
the camera.
• If the AIM/Status LED (Fig. 1) blinks, it indicates that
position can be sensed. If it does not blink, that position is
outside of the sensing area.
The results of your testing will help you find the best placement
when mounting and aiming the Tasco Trail Camera. The vertical
height away from the ground for placing the device should vary
with the animal size appropriately. In general, 3 to 6 feet is
preferred.
You can avoid potential false triggers due to temperature and
motion disturbances in front of the camera by not aiming it at a
heat source or nearby tree branches and brush (especially on
windy days).
Switching ON the Camera
Once you move the Power Switch to ON, the AIM/Status LED
will blink for several seconds. This gives you time to close
and lock the front cover of the Tasco Trail Camera and then
walk away. During this time, the AIM/Status LED will blink
10
Publicité
