Alde 3010 Instructions D'installation Et De Montage page 12

4. Set the required temperature
The temperature can be set from +5°C to +30°C in steps of 0.5°C. Warm water is always available (50°C) when the
boiler is on and running on LPG or electricity. During summer, when only warm water is required, adjust the tempera-
ture setting to below the surrounding temperature so that the central heating pump does not start.
+22°C
2 kW
Off ON On
5. Extra warm water
If you need more warm water, you can raise the water temperature temporarily from 50°C to 65°C. After 30 minutes,
the boiler reverts to normal operation. When you have selected more warm water the circulation pump stops.
+22°C
2 kW
ON
Off On
If you wish to revert to the basic warm water settings before 30 minutes have expired.
+22°C
2 kW
ON
Off On
12
1. The temperature displayed is
the temperature which is set at
present (in this case 22.0°C).
2. Raise the temperature by
pressing the + button. Lower
the temperature by pressing
the – button.
3. The settings are ready and the
central heating pump will work
at the set temperature.
1. Increase the quantity of warm
water by pressing the + button.
When activated the plus sym-
bol changes colour to green.
2. The settings are ready.
1. Reset the warm water by
pressing the – button.
2. The settings are ready.