Table des Matières
Publicité
8. TROUBLE SHOOTING
Problem
Problem
Product does not start
Product does not start
Product does not reach full
power
Product does not reach full
power
Unsatisfactory result
Unsatisfactory result
The motor does not start
The motor does not start
The bit cannot be installed
The bit cannot be installed
The motor is overheating
The motor is overheating
A
9. DISPOSAL AND RECYCLING
Electrical products must not be thrown out with domestic waste. Recycle them at the special disposal centers provided for the
purpose. Contact your local authorities or stockiest for advice on recycling.
Electrical products must not be thrown out with domestic waste. Recycle them at the special disposal centers provided for the
purpose. Contact your local authorities or stockiest for advice on recycling.
The potential
electronic equipment.
The potential
electronic equipment.
For disposal, this tool also can be returned to the hardware store or vendor (or Dexter dealer).
For disposal, this tool also can be returned to the hardware store or vendor (or Dexter dealer).
Possible cause
Possible cause
Not connected to power supply
Not connected to power supply
Power cord or plug is defective
Power cord or plug is defective
Other electrical defect to the product
Other electrical defect to the product
Extension cord not suitable for operation with this product
Extension cord not suitable for operation with this product
Power source (e.g. generator) has too low a voltage
Power source (e.g. generator) has too low a voltage
Air vents are blocked
Air vents are blocked
Drill bit is worn
Drill bit is worn
Drill bit not suitable for work piece material
Drill bit not suitable for work piece material
The tool is not connected to a power source
The tool is not connected to a power source
1. The sleeve is not released
1. The sleeve is not released
2. The bit does not fit the chuck jaw
2. The bit does not fit the chuck jaw
Ensure cooling vents are free of dust and obstacles
Ensure cooling vents are free of dust and obstacles
cts on the environment and human health as a result of the presence of hazardous substances in electrical and
cts on the environment and human health as a result of the presence of hazardous substances in electrical and
Solution
Solution
Connect to power supply
Connect to power supply
Check by a specialist electrician.
Check by a specialist electrician.
Check by a specialist electrician
Check by a specialist electrician
Use a suitable extension cord
Use a suitable extension cord
Connect to another power source
Connect to another power source
Clean the air vents
Clean the air vents
Replace with a new one
Replace with a new one
Use suitable drill bit
Use suitable drill bit
Connect the tool to a power source
Connect the tool to a power source
1. Release the sleeve
1. Release the sleeve
2. Use the appropriate bit
2. Use the appropriate bit
Clean and clear vents. Do not cover with
hand during operation
Clean and clear vents. Do not cover with
hand during operation
258
195
FR
ES
PT
IT
EL
PL
UA
RO
EN
Publicité
Chapitres
Table des Matières
Dépannage
