Maintenance; Trouble Shooting - Dexter 500HD2.5 Mentions Légales & Consignes De Sécurité

Drill screw-driver

Table des Matières

7. MAINTENANCE

Disconnect from the power supply immediately if the supply cord is damaged.

Take care not to expose this tool to the rain.

If the carbon brushes need to be replaced, have this done by a qualified repair person (always

replace the two brushes at the same time)

Cleaning

Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to damage from various types of commercial solvents and

may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.

Lubrication

All the bearings in this tool are lubricated with a su

conditions, therefore no further lubrication is required.

Suspected malfunctions are often due to causes that the users can fix themselves. Therefore check the product using this section. In most cases the

problem can be solved quickly.

authorised service centre or a similarly qualiﬁed specialist if you cannot solve the

problem yourself!

Always disconnect the device before performing any adjustment or maintenance

operation. If the supply cord of this power tool is damaged, it must be replaced by a

specially prepared supply cord available through the service organization;

WARNING! Only perform the steps described within these instructions! All

further inspection, maintenance and repair work must be performed by an

nt amount of high grade lubricant for the life of the unit under normal operating

194

257

Table des Matières

Table des Matières