Cordless Screwdriver Safety Warnings; Battery And Charger Safety Warnings - Dexter 3.6VSD2.5 Traduction Des Instructions D'origine

d) Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, ush
with water. If liquid contacts eyes, additionally seek medical help.
burns.
e) Do not use a battery pack or tool that is damaged or modi ed.
resulting in re, explosion or risk of injury.
f) Do not expose a battery pack or tool
cause explosion.
g) Follow all charging instructions and do not charge the battery pack or tool outside the temperature range speci ed in
Charging improperly or at temperatures outside the speci ed range may damage the battery and increase the risk
the instructions.
of re.
6) Service
a) Have your power tool serviced by a qual
the safety of the power tool is maintained.
b) Never service damaged battery packs.
service providers.

3. CORDLESS SCREWDRIVER SAFETY WARNINGS

Hold power tool by insulated gripping surfaces, when performing an operation where the fastener may contact hidden wiring.
Fasteners contacting a «live» wire may make exposed metal parts of the power tool «live» and could give the operator an electric shock.
. If possible, always use clamps or a vice to hold your work.
. Always switch before you put the tool down.
. Ensure that the lighting is adequate.
. Do not put pressure on the tool, such that it slows the motor down. Allow the bit to screw without pressure. You will get better results and you
will be taking better care of your tool.
. Keep the area free of tripping hazards.
. Only use accessory bits in good condition.
. Before starting, check that there is su cient clearance for the bit under the workpiece.
. Do not touch the bit away after operation. It will be very hot.
. Keep your hands away from under the workpiece.
. Never use your hands to remove dust, chips or waste close by the bit.
. Rags,cloths,cord,string and the like should never be left around the work area.
. Support the workpiece properly.
. If you are interrupted when operating the tool, complete the process and switch
. Periodically check that all nuts, bolts and othe
. When using the tool, use safety equipment including safety glasses or shield. Hearing protection, and protective clothing including safety gloves.
Wear a dust mask if the operation creates dust.
4. BATTERY AND CHARGING SAFETY WARNINGS
.
Make sure the charger cable is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
.
Do not store or use the tool in locations where the temperature may reach or exceed 45°C (such as inside sheds or metal buildings in summer).
.
The tool is not fully charged out of the carton. First read the safety instructions and then follow the charging notes and procedures.
.
The longest life and best performance can be obtained if the tool is charged when the air temperature is between 18-24°C . Do not charge
the tool in an air temperature below 10°C or above 45°C . This is important and will prevent damage to the tool.
.
Do not incinerate the tool even if it is seriously damaged or is completely worn out. The battery can explode in a re.
.
Never attempt to open the tool for any reason. If the plastic housing of the tool breaks or cracks, immediately discontinue use and do not
recharge.
.
During charging, the tool must be placed in a well ventilated area.
.
The battery utilizes lithium cells. Lithium is considered to be a toxic material. Use an environmentally safe disposal until at a municipal waste
disposal centre to dispose of a damaged or worn out battery.
Damaged or mod
re or excessive temperature.
pair person using only identical replacement parts.
Service of battery packs should only be performed by the manufacturer or authorized
xings are properly tightened.
Liquid ejected from the battery may cause irritation or
batteries may exhibit unpredictable behaviour
Exposure t or temperature above 130 °C may
before looking up.
FR
ES
PT
IT
EL
PL
UA
This will ensure that
RO
EN