THOMSON RK250UDABCD Consignes page 21

- DRC off: The dynamic range is not reduced.
- DRC high: The dynamic range is sharply reduced.
- DRC low: The dynamic range is slightly reduced.
• Prune:
It may be that you can no longer receive some stations after a station scan or change of location.
With this function you can delete these stations from the reception list. Select "YES" and confirm with
the "ENTER / PLAY / PAUSE / CLOCK" button.
• System
• Language
• Time Update
• Factory Reset
• SW version
Listening to the FM Radio
1. Select the RADIO mode with the "STANDBY / FUNCTION" button, until "FM" is shown in the
display.
2. For FM reception: Completely extend the telescopic antenna. Change its position to improve the
reception.
3. There are two options to search for and preset radio stations.
• Automatic scan:
Important! Any preset radio stations will be overridden.
Press and hold the "AMS / MODE" button for approx.3 seconds. The system scans the entire frequency
band for radio stations. Any stations found will be preset from lowest to highest frequency.
• Manual scan for audio stations:
Briefly press the "SKIP+ / TUNING+" or "SKIP- / TUNING-" buttons, until you have found the radio
station which you are looking for. If you keep one of the buttons pressed down, the device will search
to the previous, respectively next radio station.
Preset station:
1. Press and hold the "AMS / MODE" button on unit for about 2-3 seconds to start the automatic
preset process.
2. Display will show the memory sequence number and radio stations will be automatically preset
into the sequence number (Note: Each sequence number means 1 preset station while during
automatic preset process.)
3. Once all the stations were automatic preset, press the "PRE. / FOLDER" button to choose preset
stations.
Info display
Press the "INFO / SNOOZE" button to show the FM information.
FM Menu
Press "STOP / MENU" button to select the FM radio menu. Press "SKIP+ / TUNING+" or "SKIP- /
TUNING-" button to chosse the following FM menus and confirm with "ENTER / PLAY / PAUSE /
CLOCK" button:
• Scan setting: Select the desired option for automatic station search.
- All stations: Search for all stations that can be received. In this case, station search also stops for
weak stations.
- Strong stations only: Only clear stations are searched.
• Audio setting: Select the MONO or STEREO for FM reception.
- EN 7 -