DoorBird D10 Série Manuel D'installation page 5

STEP 7: ATTACH THE MOUNTING PLATE
Put the wires that you would like to connect to the video door station
through the opening in the mounting plate provided. Position the mounting
plate against the exterior wall of the house and use the screws provided to
position it in the dowels or on the wall. The mounting plate for the video
door station has been designed in such a way that it can also be installed on
uneven walls, so it is not completely flat. The partially greater clearances at
the back also serve to stabilize temperature and moisture levels.
STEP 8: PREPARING THE WIRES
Remove about 5 mm of insulation material at the end of the wires that you
would like to connect to the video door station.
STEP 9: CONNECTING THE WIRES
It is possible to connect the video door station conveniently and safely via a
connection terminal with jacks on the reverse of the video door station.
The individual contacts on the connection terminal are labelled on the reverse
of the casing. Some connectors on the connection terminal may come provided
by us with cable. Please use appropriate crimp connectors or terminal strips
to connect the supplied cables with your wires. The accompanying crimp
connectors are weatherproof and are equipped with heat-shrink tubing which
can be sealed after assembly by, for example, carefully using a heat gun.
Please remove any cables on the connection terminal that you do not need.
T+ T- R+ R- O1 O2 C1 C2 B1 B2 V- V+
8
CONNECTOR DESCRIPTION
White and orange network cable wire
T+
(Number 1, Transmit Data +)
Orange network cable wire
T-
(Number 2, Transmit Data -)
White and green network cable wire
R+
(Number 3, Receive Data +)
Green network cable wire
R-
(Number 6, Receive Data -)
Electric door opener
O1
(zero potential)
Electric door opener
O2
(zero potential)
C1 Electric door chime (zero potential)
C2 Electric door chime (zero potential)
B1 Door-opening button
B2 Door-opening button
V- Power supply, negative pole (-)
V+ Power supply, positive pole (+)
Please take care when connecting the wires. Connecting the wires the wrong
way may destroy the video door station.
STEP 10: FINAL ASSEMBLY
Mount the video door station on the mounting plate. The video door station
will click into the locking positions intended for the mounting plate. Use the
accompanying safety screw with the appropriate tool to fix the video door
station to the underside of the mounting plate.
STEP 11: ACTIVATING THE VIDEO DOOR STATION
Switch on the power to the wires leading to the assembly location again.
You can see whether you have connected the power supply properly from the
Diagnostic LED (it lights up once the power has been connected correctly
for up to five minutes and continuously in night-vision mode). The video door
station is ready for operation (booting up process, any software updates, etc.)
once it has emitted a short diagnosis sound from the integrated loudspeaker.
WIRE
white-orange
orange
white-green
green
purple
purple
blue
blue
yellow
yellow
black
red
9