Recalling A Preset Station; Clearing A Preset Station - Yamaha R-S700 Mode D'emploi

FM/AM TUNING

Recalling a preset station

You can recall preset stations that were registered using
automatic station preset or manual station preset.
1
Press PRESET j / i on the front panel (or
PRESET F / G on the remote control) to
select a preset number.
y
• Preset numbers to which no stations are registered are skipped.
• "NO PRESETS" is displayed if no stations are registered.
• You can directly select a preset number by pressing the numeric
buttons on the remote control while recalling a preset station.
"EMPTY" is displayed on the display if you enter a preset
number to which no station is registered. "WRONG NUM." is
displayed if you enter an invalid number.
• When you press the numeric buttons on the remote control
during normal tuning, a frequency is entered. Set the tuning
mode to preset tuning mode using PRESET j / i on the front
panel (or PRESET F / G on the remote control) before
pressing numeric buttons.
24
En
PRESET j / i
PRESET F / G

Clearing a preset station

Follow the steps below to clear a preset station.
CLEAR
RETURN
1
Select the desired preset station number.
See "Recalling a preset station" on page 24.
2
Press CLEAR on the front panel.
The selected preset number flashes on the front panel
display.
y
To cancel clearing the preset station, press RETURN on the
remote control or leave this unit without any operations for about
30 seconds.
3
Press CLEAR on the front panel to confirm.
"PXX: CLEARED" (XX indicates the preset
number) is displayed on the front panel display, and
then the display returns to its original state.
(Australia model)